核磁共振 » 讨论区 » 分析百问 » NMR筛选化合物活性的文章,哪大侠翻译一下!

采购询价

点击提交代表您同意 《用户服务协议》 《隐私政策》

 
需要登录并加入本群才可以回复和发新贴

标题:[未解决]NMR筛选化合物活性的文章,哪大侠翻译一下!

  [未解决]本主题悬赏 可用分 10  
xiaoyu_snow[使用道具]
三级
Rank: 3Rank: 3


UID 35948
精华 2
积分 431
帖子 121
信誉分 110
可用分 1056
专家分 80
阅读权限 255
注册 2010-4-18
状态 离线
1
 

NMR筛选化合物活性的文章,哪大侠翻译一下!

Figure 1. (a) Experimental scheme of the SEI experiment. The pulse
sequence incorporates a Gaussian-shaped pulse of angle R e 90°, followed
by a modified WATERGATE sequence for residual water signal suppression.
The rSnob profile9 is used for selective refocusing of downfield shifted
protein resonances in the spin-echo part of the experiment (the 2 ms long
rSnob is placed in the middle of the Δ ) 4 ms delay). The Gaussian pulse
has the duration of 1 ms and R of 77°. Selective pulses are applied at 10
ppm. Gradient strengths are 22% and 20% for G1 and G2, respectively; δ
was set to 100 μs, the gradient recovery delay to 100 μs, and the acquisition
time t1 to 300 ms, giving the total scan time Tscan ~ 300 ms. (b) (c) 1D 1H
NMR spectra of the 35 μM Mdm2-p53 complex; twoH signals of Trp
of p53 are visible (for the NMR properties of the complex see Figure S2).
Both spectra were acquired in 2.5 min using (b) the SEI pulse sequence
and (c) a 90° hard pulse followed by the WATERGATE-W3 sequence.

我在看JACS上一篇关于核磁共振NMR筛选化合物活性的文章,里面提及一些内容,哪位高人能否对这图的说明做个解释翻译吗?尤其是(a),我看了半天都没弄懂啥意思。是不是一些参数的设置啊?谢谢

顶部
sseia42[使用道具]
一星
Rank: 6Rank: 6


UID 14678
精华 8
积分 3319
帖子 1178
信誉分 130
可用分 4084
专家分 720
阅读权限 255
注册 2009-3-30
状态 离线
2
 
指实验参数设置,大概翻译了下a部分:
a. SEI实验脉冲序列示意图:在扳转角<=90度的高斯形状脉冲后是修改的WATERGATE序列(用于消除水的残余信号)。实验自旋回波部分的 rSnob profile用于选择性回聚低场的蛋白质共振信号(Δ时间为4ms,rSnob为2ms,居中)。高斯脉冲长1ms,扳转角为77度。选择性脉冲的中心位于10ppm处。梯度场G1和G2的强度分别为22%和20%。δ为100μs,梯度恢复延迟为100μs,采样时长t1=300ms,(giving the total scan time Tscan ~ 300 ms. 不知道啥意思)
顶部