小中大分享:核磁共振 参数in表示什么意义 核磁共振 参数in表示什么意义
参数in表示什么意义?
In有三个值:n、y、w
in Lock and spin interlock (P)
Description: Controls error handling based on lock level and spin speed, and specifies action to be taken based on lock level failure or spinner failure. The action can be to generate an error and halt acquisition, or to generate a warning and continue acquisition.
Values: Can be set to one or two characters:
• If set to two characters, the first character specifies the action for lock
failure and the second character specifies the action for spinner failure.
• If set to only one character, that character specifies the same action for
either lock or spinner failure.
'n' stops any system checking so that acquisition continues regardless of the
lock level or spin speed.
'w' makes the system check the lock level and the spin speed. A warning
message is added to the log file if the lock level falls below a preset hardware
level (about 20 on the lock meter) or if spin is set to a particular value and the
spin speed goes out of regulation; however, acquisition is not stopped.
'y' makes the system check the lock level and spin speed. Acquisition is halted
if the lock level falls below a preset hardware level (about 20 on the lock meter)
or if spin is set to a particular value and the spin speed goes out of regulation.
See also: Getting Started
我做实验时发现:
固体实验:in=‘n’,一切正常
In=‘y’ 不进行采样,出现提示:lock lost during experiment
In=’w’ 出现提示:lock lost during experiment,但是采样不停止。
|